This time I zoomed in on the form...!
And changed the section where to post it ! I had an idea maybe valid or maybe not , if the laser module 12x45mm is wrapped with aluminium adhesive tape ,you can have a proper dissipation of the heat emitting diode , and the host that in part resembles the WL 3 can be painted both inside and outside with spray acrylic act at very high temperatures (I think it holds up to 800°C) then perhaps the host of hard plastic can anyway be used instead of the aluminum ones ...thus saving time and effort especially for turning ....!
Commented....
![]()
![]()
![]()
And changed the section where to post it ! I had an idea maybe valid or maybe not , if the laser module 12x45mm is wrapped with aluminium adhesive tape ,you can have a proper dissipation of the heat emitting diode , and the host that in part resembles the WL 3 can be painted both inside and outside with spray acrylic act at very high temperatures (I think it holds up to 800°C) then perhaps the host of hard plastic can anyway be used instead of the aluminum ones ...thus saving time and effort especially for turning ....!
Commented....
