Hi, i was thinking of replacing the diode of my laser. I got a 405nm laser. I made it watertight, but at the same time, easy to swap diodes if it dies. But i want to get a 50mW PL520 osram diode.
Now, the driver board and BMS controll circuit is something hard to replace in this laser and something i don't want to replace as soldering that toghether and shaping it perfectly so everything fits takes days of hard work.
( Laser Driver Board for 5-250mW 405nm Blue-violet Laser Module | eBay )
My question is whether this driver is suitable for this Osram diode. It is a boost driver, and it could output 6.1 volts . I tested it. This driver is also no load protected and i could easily get 200mA out of it. It would be awesome if it is compatible so i could set the current for the 520nm diode, plug it in and seal it
Thanks
Edit, forgot to mention, i couldn't find any information about this anywhere
Now, the driver board and BMS controll circuit is something hard to replace in this laser and something i don't want to replace as soldering that toghether and shaping it perfectly so everything fits takes days of hard work.
( Laser Driver Board for 5-250mW 405nm Blue-violet Laser Module | eBay )
My question is whether this driver is suitable for this Osram diode. It is a boost driver, and it could output 6.1 volts . I tested it. This driver is also no load protected and i could easily get 200mA out of it. It would be awesome if it is compatible so i could set the current for the 520nm diode, plug it in and seal it
Thanks
Edit, forgot to mention, i couldn't find any information about this anywhere