Diode versus driver, pins placement?

Hi guys.

My first diode+driver replacement, but got a feeling that the two pins i have placed on drivers LD+ & LD- according to the diode +/- schematic.
But looking on the retail models, it doesnt look right..

are my minus & plus correct, or is it the other solderpoint on the other side of the driver, i should use.
On the retails ones, they are often funded in three legs, with the two active pins soldered in one joint.
Checked in the official laserbuild tread, but not much about the different driver connections)

(LD 445nm +1w likely A-model 3 string ver hence low price, but not sure, rookie on this subject) thanks for any help/guidance :)






http://1drv.ms/1SMJW23

http://1drv.ms/1SMJX64

http://1drv.ms/1SMK1CR