Hi
Ok not the best choice of host for this great diode but took a lot of work
Drilling and connecting the stainless switch in the rear, had to make a special
Tool to fit all the way in the host and tighten the nut for the switch without ripping the wires, and then making a sleave with a spring for the positive
Connection, so it's a boost driver set to 480ma and producing 190mw with G2
Lens last time I metered it, a bit of artifacts with the G2 but the beam is very tight and nice, I might have a faulty G2 on this one.
I've built this host with the side switch in the past, so I went with a different approach this time.
Thanks for looking.
Ok not the best choice of host for this great diode but took a lot of work
Drilling and connecting the stainless switch in the rear, had to make a special
Tool to fit all the way in the host and tighten the nut for the switch without ripping the wires, and then making a sleave with a spring for the positive
Connection, so it's a boost driver set to 480ma and producing 190mw with G2
Lens last time I metered it, a bit of artifacts with the G2 but the beam is very tight and nice, I might have a faulty G2 on this one.
I've built this host with the side switch in the past, so I went with a different approach this time.
Thanks for looking.