FS: No Diode DIY Host Kits

Why hello, everyone! I need to make some room for some new hosts so I figured why not sell off someone of my older ones!

What I have here are a few hosts which contain:
One XM-L2 aluminum host
One Polished aluminum heatsink for a 12mm module with setscrew
One battery contact board contain battery spring
One positive and one negative wire going from contact board to your module (module not included unless asked)
One green strap

These hosts are module ready, you just need a diode pressed module, and a corresponding driver for said diode. Solder the wires to the correct driver solder pads, slide you module in the heatsink, set the set screw, and you're ready to add batteries!
For higher powered builds that require extra cooling of the driver, there is a spot on the pill that holds a driver perfectly with thermally conductive adhesive.

$40 Shipped CONUS
If you would like to buy more than one, PM me, and we'll figure up a price! :) Thanks

Attached Thumbnails