Question for you guys...
I have a host with a switch that has 3 modes -- output 1, output 2, off.
Say I want to keep this setup, and drive a (case negative) diode at 100mA (output 1), 275mA (output 2), off. (micro flex v5, nano)
Can I just hook up two separate drivers to the separate switch outputs and be on my way? Or what would I need to do in order to not kill anything?
I don't know much about electronics so I'd prefer to be safe before I start planning anything.
-Z
I have a host with a switch that has 3 modes -- output 1, output 2, off.
Say I want to keep this setup, and drive a (case negative) diode at 100mA (output 1), 275mA (output 2), off. (micro flex v5, nano)
Can I just hook up two separate drivers to the separate switch outputs and be on my way? Or what would I need to do in order to not kill anything?
I don't know much about electronics so I'd prefer to be safe before I start planning anything.
-Z