Picked up a flashlight that has a pretty good throw but not as strong as my 12T6 so a host it is, holds 2 or 3 x 26650 with sleeves for 18650's, has an extension that's removable of course if you want to run 2 cells, but why, 3 are much better.
The spring board is 26mm wide and the head will hold a 2.125 that's 2 1/8 inch wide length of bar stock ( pic is without trim/bezel ring that is 1.125 in the clear) or you could have cut a custom sink, not a bad host for 29 dollars shipped, I stripped the board to reuse and will either use a 2 inch length of bar stock or possibly get someone with a lathe to make one as the fins are pretty nice, there's plenty of room under the wide portion of the head for your drivers before you hit the springboard, about 1.25 inches x 1.25 or a hair under.
These things can vary so I'm not going to measure everything in detail, just order your own and build to fit as these things can change a few mm from lot to lot.
Pretty cool looking host, should have a long runtime and stave off power drop with a large sink.
http://www.ebay.com/itm/Outdoor-Trus...3D141761145377
![]()
![]()
![]()
![]()
![]()
![]()
![]()
![]()
The spring board is 26mm wide and the head will hold a 2.125 that's 2 1/8 inch wide length of bar stock ( pic is without trim/bezel ring that is 1.125 in the clear) or you could have cut a custom sink, not a bad host for 29 dollars shipped, I stripped the board to reuse and will either use a 2 inch length of bar stock or possibly get someone with a lathe to make one as the fins are pretty nice, there's plenty of room under the wide portion of the head for your drivers before you hit the springboard, about 1.25 inches x 1.25 or a hair under.
These things can vary so I'm not going to measure everything in detail, just order your own and build to fit as these things can change a few mm from lot to lot.
Pretty cool looking host, should have a long runtime and stave off power drop with a large sink.
http://www.ebay.com/itm/Outdoor-Trus...3D141761145377
