Custom Sinner host builds

Hi guys this is my new FS thread for Sinner custom built lasers.:wave:

These are the hosts I have available.





Here you can see the copper pressed heat sinks used in these hosts :)




Here are two new completed builds; one with an NUBM07E diode and the other with an NUBM44.

Specs 465 5.8 W 07E

Sinner MS V1 host (new design) with focus ring
NUBM07E diode
Copper Module with extended copper back half
Lazeeerer SXD with pot set at 4 A and heat sinked directly to host
G lens
24AWG super flexible silicone wire
Takes 2 x 16340 batteries (not supplied)
$ 367 shipped - includes priority shipping with tracking
Please note Paypal fees applicable if payment not sent as F&F.




Specs 7 W 450 M44

Sinner MS V1 host (new design) with focus ring
NUBM44 diode
Copper Module with extended copper back half
Lazeeerer SXD with pot set at 4.5 A and heat sinked directly to host
G lens
24AWG super flexible silicone wire
Takes 2 x 16340 batteries (not supplied)
$ 347 Shipped - includes priority shipping with tracking
Please note Paypal fees applicable if payment not sent as F&F.



These are the completed V1s :)





Here you can see them both in action! They are both extremely bright and the 465 is actually ever so slightly more teal in colour than the camera shows it.



Notes: I dont actually know what the duty cycle of these lasers are, however as I prefer to look after my diodes, I generally stick to shorter run times to extend their lifetimes. As a guideline, I would recommend 1 min on and 1.5 mins off - at 1 min the head of the laser will be getting warm.

For those of you not aware of multimode diodes the output is bar shaped and very similar to the M140 diodes ie not a tight dot.

** Note to buy a completed laser you must be over 18 and own the correct pair of safety goggles for your chosen wavelength. Please feel free to PM me for further details. **