Hi forum!
I'm near to terminate a very very beautiful and complex handeld with two 1W greenies, but I need help.
So, I have a pair of blackbuck 8M 8A drivers set at 4.5A each, but I want to use only one set at 2.3A with two 520nm NDG7475 diodes in series.
I will use also the external trim pot to vary the output from min to the max power and viceversa.
My question is: can this device drive both the diodes in series at 2.3A (and I suppose at 10V) without any kind of issues?
And .. what kind of test load I must build to preset the driver at 2.3A to work correctly with two NDG7475 diodes in series?
Thanks in advance ... :thanks:
I'm near to terminate a very very beautiful and complex handeld with two 1W greenies, but I need help.
So, I have a pair of blackbuck 8M 8A drivers set at 4.5A each, but I want to use only one set at 2.3A with two 520nm NDG7475 diodes in series.
I will use also the external trim pot to vary the output from min to the max power and viceversa.
My question is: can this device drive both the diodes in series at 2.3A (and I suppose at 10V) without any kind of issues?
And .. what kind of test load I must build to preset the driver at 2.3A to work correctly with two NDG7475 diodes in series?
Thanks in advance ... :thanks: