Ultrasabers The Guardian Unboxing and Dimensions **WARNING PIC HEAVY**

Now, the moment you all have been waiting for...well about 5 of you but you get the point :p

The following are pictures and dimensions for Ultrasabers "Guardian" empty hilt. I ordered it with the guarded switch hole and also purchased the latching guarded switch. The host can be purchased here in the link below.
The Guardian | DIY Empty Saber Hilt| Ultrasabers.com

This is the box it was shipped in.
http://i.imgur.com/LCVDILL.jpg


Here is how the switch and locking screw wrench wereplaced in the box.
http://i.imgur.com/GRb9rfh.jpg


Here is the package close up.
http://i.imgur.com/Vokrvjs.jpg


Here is the package opened up.
http://i.imgur.com/SJ02wmR.jpg


I cut open the top of the box so you could see how it was packaged.
http://i.imgur.com/8Stko6K.jpg


Here is what I think is the lightsaber :P
http://i.imgur.com/sEwpsHU.jpg


FINALLY THE LIGHTSABER OMG OMG OMG OMG!!!
http://i.imgur.com/mPeXS73.jpg


WOOT REVERSE SIDE OMG OMG OMG OMG!!!!
http://i.imgur.com/B6EeRhM.jpg


Close-up of the top opening where the locking screw can be seen.
http://i.imgur.com/SaacAfs.jpg


Close-up of the bottom opening where the battery goes in.
http://i.imgur.com/i8VFvem.jpg


Here is the battery screw-cap
http://i.imgur.com/v56UpLy.jpg


Here is the measurement of the battery opening.
http://i.imgur.com/asPvaBX.jpg


Here is the measurement of the top opening.
http://i.imgur.com/IeQIH2K.jpg


Here is the measurement of the battery screw-cap.
http://i.imgur.com/Ip049CL.jpg


Here is the measurement of the distance between the bottom of the button hole and the battery opening hole. The start of the battery opening is not at the first metal part, it starts at the farthest right portion of the thinnest part of the plastic end-cap.
http://i.imgur.com/noTt3sm.jpg


I will be putting my NUBM44 laser diode in 25mm module ran at 4.5 Amps into this host and will be posting my build when its all finished! I am very excited to make this laser lightsaber!!









****UPDATE****
I found out that there is an extra screw cap on the battery end opening... I did not notice it at first because it was soo hard to unscrew (I think they glued it) that I thought it was part of the main body. Apparently not! Here are the pics of a few more dimensions.

Here is the extra screw cap that I finally removed. This is going to make the build muchhh much easier.
http://i.imgur.com/JKxoE8E.jpg


Here is the dimension of the inner diameter of the 2nd female screw cap end.
http://i.imgur.com/WdsKQlh.jpg


Being able to remove this second screw cap is going to make the build much much easier now that I can fit the main body with a shim of the sort to serve the function of a battery holder now that there is clearance between the OD of the 32650 battery and the host. :D